No Profanity *** No Flaming *** No Advertising *** No Anti Trappers *** No Politics
No Non-Target Catches *** No Links to Anti-trapping Sites *** No Avoiding Profanity Filter
Since of course I lost this one, lol, the new one I made was from an old screwdriver, slightly smaller diameter. Cut the groove with a over sized cutting wheel on a rotary tool like a big Dremel tool. I think it works even better than the original.
Rolled this way the tags make a pretty good wammy (support collar) in a pinch too.
~ADC~
Re: Small tip for snare builders - rolling tags
[Re: ~ADC~]
#6298929 08/10/1810:43 PM08/10/1810:43 PM
Great Idea. I don't build my own CRs but I do build my own earth anchors and all my tags are attached to my anchors not the CR. So this will work great for that application.
The forum Know It All according to Muskrat
Re: Small tip for snare builders - rolling tags
[Re: ~ADC~]
#6692830 12/14/1912:09 AM12/14/1912:09 AM
So those old screw drivers with the slot that went into the plastic handle that held (what you did not need but always needed) would do the same. In the drill chuck.