Made this for pushing in aluminum pins easy on the hands

what size pipe?

It was stainless stock 3/8 inch then bored on lathe made this about five years ago

I could use one of those. A have mostly cypress boards and they have some hard spots.

I’ll get the dimensions and hole size and depth tomorrow I hope

3/8 inch stainless stock; horizontal handle 3.5 inches; vertical riser 2.5 inches; 9/32 hole 3/8 inch depth but would depend on your pins you are using…Jon

Thanks@

I bet that would sell if someone fabricated some for sale.

Steve I believe you are right . I made one for me, a buddy and my cousin they really like it . I just got tired of using my hands or pliers on boards and dreamed this up ... Jon

I like it. I think it needs a way to pull them also.

2 Traps I like that idea , the only draw back is you can push the pin in to far because it makes it easy time saved is also a big plus